Supermicro X12SPW-TF - Page 96

Super X12SPW-TF/F User's Manual
96
MMCFG Base
Use this feature to select the low base address for PCIe adapters to increase base memory.
The options are 1G, 1.5G, 1.75G, 2G, 2.25G, 3G, and Auto.
NVMe Firmware Source
The feature determines which type of NVMe rmware should be used in your system. The
options are Vendor Dened Firmware and AMI Native Support.
VGA Priority
Use this feature to select VGA priority when multiple VGA devices are detected. Select
Onboard to give priority to your onboard video device. Select O󰀨board to give priority to your
graphics card. The options are Onboard and O󰀨board.
Onboard Video Option ROM
Use this feature to select which rmware function to be loaded for LAN1 used for system
boot. The options are Disabled and EFI.
M.2-H OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot.
he options are Disabled and EFI.
Onboard LAN Device
Use this feature to select which rmware function to be loaded for LAN1 used for system
boot. The options are Disabled and Enabled.
*If the feature above is set to Disabled, Onboard LAN2-6 are available for conguration:
Onboard LAN1 Option ROM
Use this feature to select a desired rmware function to be loaded for onboard LAN2 - LAN6.
The options are Disabled and EFI.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied Extensible
Firmware Interface) for network stack support. The options are Disabled and Enabled.
Onboard NVMe1 - NVMe4 Option ROM
Use this feature to select a desired rmware function to be loaded for onboard NVMe1 -
NVMe4. The options are Disabled and Legacy (if the Boot Mode Select feature under the
Boot tab is set to Legacy), Disabled and EFI (if the Boot Mode Select feature under the Boot
tab is set to UEFI), and Disabled, Legacy, and EFI (if the Boot Mode Select feature under
the Boot tab is set to Dual).