Supermicro X13SRA-TF - Chapter 1 Introduction

2280 M.2 Device Installation
X13SRA-TF QUICK REFERENCE GUIDE
2280 M.2 Device Installation
1. Locate the pre-installed standoff and
screw. Remove the screw and set it aside.
2. Using a hex socket screwdriver, remove
and then re-install the stando󰀨 to the posi-
tion of the 2280 mounting hole.
3. Insert the M.2 device into the M.2 socket
at a 30-degree angle and press it down.
4. Tighten the screw to secure the M.2 device
into place. Do not overtighten so as to
avoid damaging the M.2 device.