Need help?Do you have a question about the Supermicro SuperServer series and is the answer not in the manual?
General| Manufacturer | Supermicro |
|---|---|
| Category | Server |
| Product Line | SuperServer |
| Processor Support | Varies by model (Intel Xeon, AMD EPYC) |
| Memory Support | Varies by model (DDR4, DDR5, ECC) |
| Storage Support | Varies by model (SAS, SATA, NVMe) |
| Management | IPMI, Redfish |
| Operating System Support | Windows Server, Linux, VMware |
| Power Supply | Varies by model (redundant, non-redundant, 80 PLUS, etc.) |
| Form Factor | Tower, Rackmount, Blade |
| Expansion Slots | Varies by model (PCIe, PCI-X, etc.) |
Details the main hardware specifications and components of the E200-9AP.
Procedure for safely disconnecting the system from all power sources.
Details on the processor, memory support, and installation procedures.
Guidance on installing the hard drive into the chassis.
Pin definitions for the main ATX power supply connector (JPW1).
Explanation of jumper settings and procedure for CMOS clear.
Instructions on downloading and installing system drivers and utilities.
Overview of the SuperDoctor 5 system monitoring utility.
Configuration options for advanced system settings.
BIOS settings related to CPU information, power, and performance.
Configuration options for boot device order and priorities.
Options for saving changes, resetting, or exiting the BIOS setup.
Warning about disconnecting all power sources before servicing.
Warning that only trained personnel should install or service equipment.
Warning about the danger of explosion during incorrect battery replacement.
Warning about hazardous moving parts in hot-swap fan assemblies.
Warning about using only designated power cables and adapters.
Procedure to recover UEFI BIOS using a USB flash drive.
To Next Page