Supermicro SuperServer series - Accessing the System

17
Chapter 2: Maintenance and Component Installation
2.2 Accessing the System
The SC101S features a removable top cover to access to the inside of the chassis.
Removing the Top Cover
1. Power down the system as described in section 2.1.
2. Remove the two side screws that hold the chassis cover in place and set these aside for
later use.
3. Slide the cover sideways as illlustrated above to release the front and rear cover hooks
from the chassis.
4. Lift the cover up and off the chassis.
Caution: Except for short periods of time, do not operate the server without the cover in
place. The chassis cover must be in place to allow proper airow and prevent overheating.
Figure 2-1. Removing the Chassis Cover
2
3
Cover Hook
Cover Hook