Supermicro X13SRA-TF - Device Installation

M.2 Device Installation
M.2 Device Installation
X13SRA-TF QUICK REFERENCE GUIDE
Note 1: It is strongly recommended that you install a heatsink on the M.2 device or use a M.2 device
with a built-in heatsink.
Note 2: Be sure to install the M.2 device(s) prior to placing the motherboard into a chassis.
This motherboard has two M.2 M-key sockets that support the 2280 and 22110 M.2 devices.
One stando󰀨 and a screw are pre-installed into the position of each 22110 mounting hole.
Refer to the illustration below for the locations of M.2 sockets and mounting holes. Follow
the steps on the next two pages to install the M.2 device.
SP1
X13SRA-TF
DESIGNED IN USA
REV:1.01
22110
2280