To Next Page

To Previous Page

Chapter 4: AMI BIOS

4-19

VGA Priority

This feature allows the user to select the graphics adapter to be used as the primary

boot device. The options are Onboard, and Offboard.

Network Stack

Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unied

Extensible Firmware Interface) for network stack support. The options are Enabled

and Disabled.



Super IO Conguration

Super IO Chip

Displays the Super IO chip type.



Serial Port 0 Conguration

The submenus allow the user to congure the following settings for Serial Port 0:

Serial Port

Select Enabled to enable a serial port specied by the user. The options are

Enabled and Disabled.

Device Settings

This feature indicates whether or not a reset is required for a serial port specied.

Change Settings

This option species the base I/O port address and the Interrupt Request address

of Serial Port 0. The options for Serial Port 0 are:

Auto,

IO=3F8h; IRQ=4;

IO=3F8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;

IO=2F8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;

IO=3E8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;

IO=2E8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;

P/S 2 Connector

This option enables the selection of keyboard or mouse for the PS/2 connector.

The options are Keyboard or Mouse.

Supero X9DAi User Manual

Questions and Answers: