Supmeter BST100-E21 - Dynamic Span Calibration

6.4.2 Dynamic Span 6.4.2 Dynamic Span
CalibrationCalibration
Let the belt weigher run with loading measured materials or Poise Weights for correcting SpanLet the belt weigher run with loading measured materials or Poise Weights for correcting Span
Coefficient.Coefficient.
After running the last After running the last
revolution:revolution:
End 5REnd 5R
[ENT]: Input…[ENT]: Input…
2 Span Cal. Dyn.2 Span Cal. Dyn.
W: 499.2kgW: 499.2kg
【【
ENTENT
】】
Flow: 12.6t/hFlow: 12.6t/h
Wait… 1.00mWait… 1.00m
2 Span Cal. Dyn.2 Span Cal. Dyn.
W: 489.2kgW: 489.2kg
Main Display InterfaceMain Display Interface
【【
MENUMENU
】】
++
【【
▲▲
】】
【【
▼▼
】】
: F2 Calibration: F2 Calibration
【【
ENTENT
】】
++
【【
▲▲
】】
【【
▼▼
】】
: 2 Span Cal. Dyn.: 2 Span Cal. Dyn.
【【
ENTENT
】】
& Start loading& Start loading
MM
Remainder length of a Remainder length of a
revolutionrevolution
Flow: 12.6t/hFlow: 12.6t/h
01R 10.00m01R 10.00m
2 Span Cal. Dyn.2 Span Cal. Dyn.
W: 1.0kgW: 1.0kg
Revolution CountRevolution Count
【【
▲▲
】】
【【
▼▼
】】
::
Display FDisplay F
low, Load , AD Valuelow, Load , AD Value
Stop loading &Stop loading &
【【
ENTENT
】】
0000500.0000500.
00
[kg][kg]
R:0.1-9999999.9R:0.1-9999999.9
Input WeightInput Weight