OPERATION
To fill the Kettle with water remove it from the power base and open the lid by pressing down. The
Kettle has minimum (16 Oz) and maximum (60 Oz) marks. Too little water will result in the Kettle
switching off before the water has boiled.
NOTES:
• Do not fill the water over the maximum level, as water may spill out of the spout
when boiling.
• Ensure that the lid is firmly closed before connecting the power cord to the outlet.
• After the lid is securely closed position the Kettle on the power base. Make sure the Kettle is in
contact with the power base completely.
• Connect the Kettle to the Power Base. The light at the bottom of the kettle will start with red,
move to green and then move to white. The kettle has then completed startup and enters
the active state.
• In the active state the Kettle defaults to the initial setting of Boil and waits for the next
operation.
BEFORE INITIAL USE
If you are using the kettle for the first time, it is recommended that you clean your kettle before use
with mild soap and water. It is also recommended that you boil a full kettle of water and discard
before using.
98
To Next Page
Loading...