POURING WATER
USING THE INFUSER
USING THE SPOUT FILTER
STORAGE
CARE AND CLEANING
Lift the Kettle from the power base and then pour the water.
The Kettle may be stored on the power base when not in use.
NOTE: Ensure the lid is firmly closed. The water will spill if the lid is left open during boiling.
NOTE: Operate carefully when pouring the liquid from your Kettle as contact with boiling liquid
may result in burns.
NOTE: Ensure power supply is turned off when Kettle is not in use.
BOIL-DRY PROTECTION
Should you accidentally allow the Kettle to operate without water; the boil-dry protection will
automatically switch it off. If this should occur, allow the Kettle to cool before filling with cold water
and re-boiling.
Place the infuser into the kettle before starting the heating process. The round edge should face
forward (toward spout) and the flat edge will be in the back (toward handle). Secure Infuser into
holder within the Kettle to ensure it fits squarely. Using a spoon, carefully add tea leaves, loose tea
or tea bags to the tea infuser after the heating process is complete. Securely close the lid. Steep
tea according to tea instructions. Tea should steep an average of 4 minutes. Steeping too long
will cause the tea to become bitter.
Caution: Use extreme caution when adding tea to the tea infuser. The Kettle becomes very hot
during the boiling process. Avoid using fingers or hands directly to add tea to the infuser.
The spout filter can be inserted into the spout of the Kettle to filter out any tea leaves. To insert
the spout filter, open the lid of the Kettle, and place it in the spout from the inside of the Kettle. To
remove it, gently press down on the plastic tab holding it in place and it will release.
NOTE: Never attempt to insert or remove the spout filter while the Kettle is hot as burns can occur.
Always wait for the Kettle to fully cool before inserting or removing the spout filter. Make sure to
clean the spout filter at regular intervals.
When not in use or storage, the power cord may be wound around the cord storage under the
base of Kettle.
Any servicing should be performed by an authorized service representative.
Always disconnect the appliance from the power outlet and leave it to cool down completely
before cleaning. Never immerse the Kettle or cord in any liquid, or allow moisture to contact with
these parts.
WARNING: Be careful to avoid any spillage during cleaning, filling or pouring. Always follow the
cleaning instructions;
1. Unplug the appliance.
2. Do not clean the Kettle while hot. Allow it to cool completely before cleaning.
3. Clean with a damp cloth or sponge.
4. Never immerse the Kettle in water or put it under running water.
Removal of Mineral Deposits
Mineral deposits in tap water may cause the Kettle’s interior to discolor. To remove this build-up,
use non-toxic Liquid Descaler.
Alternative Descaling Method
1. Fill the Kettle with 3 cups of white vinegar and the remainder with water and allow to stand
overnight. Do not boil.
2. Empty the solution from the Kettle. Any stains remaining inside the spout can be removed by
rubbing with a damp cloth. Fill the Kettle with clean water, bring to boil and then discard the
water. Repeat this process one more time, and the Kettle will then be ready to use.
Cleaning External Housing
Wipe the external housing with a mild soap and damp cloth or cleaner.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of
the Kettle.
Cleaning the Filter
Remember to clean the filter with a sponge and damp cloth at regular intervals.
1312
To Next Page
Loading...