FUNCTIONS
Press the “+” or “-” button in the active state to select a tea function, and then press the Start/
Stop button to begin the heating process. The color at the bottom of the kettle will change to red.
When the heating process is complete, the color will turn green and move to the Keep Warm state.
When boiling water, the display will show the temperature changes by 1 F or 1 C.
After the selected water temperature has been reached, the sound prompt will beep one time,
and the kettle will automatically switch to Keep Warm state.
To stop or pause the heating process, press the Start/Stop button. The Kettle will stop heating and
return to the active state, but the chosen tea function will remain selected.
To switch the tea function selection while the water is already heating, press either the “+” or
“-” button.
The light will turn white. After 3 seconds, the Kettle will confirm the new selection. The Kettle has a
tea selection memory function with uninterrupted power supply.
NOTE: Tea function selection cannot be made in Keep Warm state.
KEEP WARM
After the water temperature of tea reaches the standard temperature, it will be automatically
switched to Keep Warm state and with a duration of 60 minutes. To cancel Keep Warm, press the
Start/Stop button, and the Kettle will return to the active state.
The light is green in the Keep Warm state.
STANDBY STATE
If there is no operation for 60 seconds, the Kettle will enter a Standby State. After 60 minutes of the
Keep Warm state, the Kettle enters the Standby State automatically. In the Standby State, all lights
and display are off. When in standby, press any button to go back to active state.
Function
Temperature
(°C)
Temperature
(°F)
Keep Warm
Temperature (°F)
Keep Warm
Time (Min)
Boil
100 212 195 60
Herbal
100 212 195 60
Black
100 212 195 60
Oolong
90 195 165 60
White
85 185 165 60
Green
79 175 165 60
Delicate
71 160 140 60
DISPLAY PANEL
There are three light indicator modes:
White Light - Kettle is in active state.
Red Light - Kettle is heating.
Green Light - Kettle has completed heating and is in Keep Warm mode.
If the display is off, press the Start/Stop button to enter the active state. The display is a
combination of touch buttons and LED lights. There will be a sound prompt every time a button is
pressed, and another sound prompt at the end of an operation.
To Switch Between Celsius and Fahrenheit
Press and Hold “+” and “-” at the same time for 3 seconds, until you hear a beep, and the
temperature unit will switch between Celcius and Fahrenheit.
To Select a Tea Function
• Press the “+” or “–” buttons
To Start or Stop the Kettle
Start/Stop button will start or stop the operation of the Kettle.
1110
To Next Page
Loading...