Need help?Do you have a question about the Sutron XLink 500 and is the answer not in the manual?
General| Brand | Sutron |
|---|---|
| Model | XLink 500 |
| Category | Controller |
| Language | English |
Provides steps for installing or replacing modem cards like Cell or Iridium.
Guides on proper earth ground connection and connecting the power supply.
Instructions for connecting SDI-12, RS-485, Pulse, Analog, and other sensor types.
Guides configuring sensor measurements within the LinkComm software.
Details on downloading data and uploading setups using a USB drive.
Details setting up password protection levels: Disabled, Setup, Maintenance, Full.
Explains various settings for configuring sensors, including type, label, units, and defaults.
Details settings specific to each measurement type like Analog, SDI-12, Digital, etc.
Covers slope, offset, equations, and syntax for data processing.
Explains how to set up alarms, thresholds, deadbands, and notification modes.
Details enabling telemetry, radio types, transmission kinds, and schedules.
Details configuration for cellular modem connectivity, including Tx mode and protocol.
Provides configuration details for Iridium modem connectivity and global settings.
Explains settings for enabling and managing the Wi-Fi hotspot for on-site connections.
Covers Iridium module capabilities, antenna placement, and message handling.
Details cellular modem capabilities, including data delivery and SMS notifications.
Explains how to retrieve missing data on-site or remotely.
Details configuration for Modbus master and slave operation over various interfaces.
To Next Page