Suyncll AMD005284 - Assembly Steps (Continued); Step 6: Garden Hose Adaptor Connection; Step 7: Garden Hose and Faucet Connection

10
Step 6
Connect the garden hose adaptor (female coupler) to the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adaptor . The garden hose must have an internal diameter of at
least 13 mm (1/2 in.) and must be reinforced. The water supply must be at least equal to the washer delivery
capacity.
This end to the
water inlet on
the unit
Garden hose
(male end)
Water inlet
(female coupler)
Garden
hose
Step 7
Attach the hose connector to pressure washer. Before attaching the connector to the
male fitting, remove the plastic cap, which is inserted onto the male fitting on the
pressure washer before shipping. This plastic cap can be discarded once removed. After
both components have been installed, attach the garden hose with connector screw on
the pressure washer. Connect the garden hose to the waterspout.
Finally, connect the
hose connector to the faucet.
12