AN650/AK7 (’07-MODEL) 19
Check 2
1) Click the button
1 and decrease the “Spec”
2 to 1 050 rpm
slowly.
2) Check that the “Desired idle speed”
3 is nearly equal to the
“Spec”
2. At the same time, check that the number of steps
4 in the ISC valve position decreases
.
NOTE:
It takes a few seconds for “Desired idle speed” to catch up with
the changed value of “Spec”.
3) Click the button
5 and increase the “Spec”
2 slowly.
4) Check that the “Desired idle speed”
3 is nearly equal to the
“Spec”
2. Also, check that the number of steps
4 in the ISC
valve position increases
.
Check 3
1) Click the button
1 and increase the “Spec”
2 to 1 400 rpm
slowly.
2) Check that the “Desired idle speed”
3 is nearly equal to the
“Spec”
2. Also, check that the number of steps
4 in the ISC
valve position increases
.
SAMPLE
To Next Page
Loading...
