18 AN650A/K7 (’07-MODEL)
ACTIVE CONTROL INSPECTION (ISC RPM CONTROL)
Check 1
1) Place the motorcycle on the center stand.
2) Pull the parking brake lever and make sure that the rear
wheel is locked.
3) Set up the SDS tool. (Refer to the SDS operation manual for
further details.)
4) Check that the engine is running.
5) Click the “Engine and Transmission”
1.
6) Click the “ISC rpm control”
2.
7) Check that the “Spec”
3 is idle speed 1 200 ± 100 rpm.
8) Check that the “Desired idle speed”
4 is within the specified
idle rpm.
SAMPLE
To Next Page
Loading...
