2-23
NOTE:
• The grip heater has a built-in auto-
matic switch to avoid unnecessary
battery power consumption. The
automatic switch turns off grip
heater when the engine speed
becomes lower at engine idling
speed. When the engine speed
increases, the automatic switch
turns on grip heater.
• Pushing the switch will not turn on
the grip heater when the engine
speed is low. Increase the engine
speed and push the switch again
to turn on the grip heater.
TURN SIGNAL LIGHT SWITCH
“” 9
Moving the switch to the “” position
will flash the left turn signals. Moving
the switch to the “” position will
flash the right turn signals. The indi-
cator light will also flash intermittently.
Push in the switch to cancel the turn
signal operation.
WARNING
Improperly using the grip heater
can be hazardous. Rider can suf-
fer burns even if the heating tem-
perature is fairly low when the
rider is wearing no gloves and
leaves the heater on for long peri-
ods. Damaged grip can suffer
burns or get an electrical shock.
• Be sure to wear gloves to avoid
burns.
• Replace the damaged grips to
avoid burns or electrical shock.
:
:
:
4 3
2
Full light
Half light
Tu r n of f
1:MIN
5:MAXOFF
WARNING
Failure to use the turn signals,
and failure to turn off the turn sig-
nals can be hazardous. Other driv-
ers may misjudge your course and
this may result in an accident.
Always use the turn signals when
you intend to change lanes or
make a turn. Be sure to turn off
the turn signals after completing
the turn or lane change.
To Next Page
Loading...
