6-25
9. Replace the drain plug gasket 3
with a new one. Reinstall the drain
plug 2 and gasket 3. Tighten the
plug securely with a torque
wrench. Pour 2900 ml (3.1/2.6
US/Imp. qt) of new oil through the
filler hole and install the filler cap.
Be sure to always use the speci-
fied engine oil described in the
FUEL, ENGINE OIL AND COOL-
ANT RECOMMENDATIONS sec-
tion.
Drain plug tightening torque:
23 N·m (2.3 kgf-m, 16.5 lbf-ft)
NOTE: About 2600 ml (2.7/2.3 US/
Imp. qt) of oil will be required when
changing oil only.
10. Start the engine (while the motor-
cycle is outside on level ground)
and allow it to idle for three min-
utes.
11. Turn the engine off and wait
approximately three minutes.
Recheck the oil level on the
engine oil inspection window while
holding the motorcycle vertically. If
it is lower than the “L” line, add oil
until the oil level is between the “L”
line and the “F” line. Inspect the
area around the drain plug and oil
filter for leaks.
NOTE: If you do not have a proper oil
filter wrench, have your Suzuki dealer
perform this service.
NOTICE
Engine damage may occur if you
use oil that does not meet
Suzuki’s specifications.
Be sure to use the oil specified in
the FUEL, ENGINE OIL AND
COOLANT RECOMMENDATIONS
section.
To Next Page
Loading...
