Suzuki df2.5 - Page 112

CLAMP BRACKETITHRUST B LOCK
• Apply the Water Resistant Grease to the clamp bracket
through swivel shaft
bolt hole.
" Inst
al l the clamp bracket starboard side G) , the tilt friction
washer@ and the swivel shaft bolt @.
SUZUKI WATER RESISTANT GREASE
.. Install the thrust block® with the lower thrust mount and the
tilt lock bolt@ .
" Insta
ll the tilt friction washer ® and the clamp bracket port
side
(f).
" Install
the tilt friction washer@ and the swivel shaft nut® .
" Tighten the swivel shaft nut to the specified torque.
shaft nut: 10 N·m (1.0 kg -m, 7.0 lb-ft)
$ Apply the Thread Lock to the swi v el shaft nut.
99000-32050: THREAD LOCK "1342"
• install the tilt lock spacer ®land the tilt lock wing nut® .
.. Install the tilt lock pin ® to the tilt lock bolt.
MID UNIT 7·9