Installation is reverse order of removal
to
the following steps.
the attention
Install the two dowel pins
housing.
and
onto the drive-
Do
not
re-use
the
gasket
once
removed.
Always
use
new
parts.
2.
Apply the Water Resistant Grease to the driveshaft
99000-25161: SUZUKI WATER
3.
Apply the Water Resistant
driveshaft
oil seal.
to
the seal
99000-25161:
WATER RESISTANT
4.
Install the oil seal protector and the bolt
applying the Thread Lock to the bolt.
99000-32050:
THREAD
"1342"
5.
Install the power unit to the lower cover, then tour
bolts to the specified
Lower
cover
bolt:
8 N·m
6.0
To Next Page
Loading...
