REASSEM
Reassembly
is
reverse order of disassembly with the special
attention to the following steps.
1.
Apply engine
oil
to the valve stem seals
2.
Install the valve stem seals to the valve guide.
3.
Apply engine oil
to
the
valve guide bore and valve stem.
4.
Install the valve
(2)
to the valve guide.
5.
Install the valve spring@ and the retainer
NOTE:
Reassemble each valve spring
to
their original position.
6.
Push down the retainer with both thumbs to admit the valve
stem into the side hole of the retainer, and let it slide side-
wise into the center
hole.
7.
Make sure the retainers are properly seated
in
groove
POWER
UNIT
6-17
To Next Page
Loading...
