Suzuki df2.5 - Page 88

to groove clearance
the must be and free
of carbon.
Fit
ance between the
gauge.
and measure the clear-
groove using the thickness
IT'ooh 09900·20803: Thickness gauge
to clearance:
1st & 2nd 0.020-0.060 mm
Service limit:
1st&2nd 0.120mm
the measurement exceeds the service
ton and/or the
width:
Standard:
st & 2nd 1.21 -1.23 mm
Oil 1.51 -1.53 mm
Piston thickness:
Standard:
1st & 2nd 1.17 - 1.19 mm
Piston end gap
Measure the piston end the
est of the cylinder bore.
&r'OOh 09900-20803: Thickness gauge
Piston end
Standard:
1st & 2nd 0.15-0.35 mm
""'""'""'.-·"" limit:
1st & 2nd 0.50 mm
the measurement exceeds the service
tion
replace the pis-
-0.049
-0.060
-0.047
in the low-
-0.014
POWER UNIT 6·25