Suzuki df2.5 - Page 91

6-28
UNIT
end oil clearance
the clearance as follows.
the surface of the the conrod cap and the
crank pin.
2. Place a piece the piastigauge on the crank parallel to
the crankshaft, avoiding the
oil hole.
09900-22301: Plastigauge
3. Install the conrod and the conrod cap to the crank
4. Install the two conrod bolts and bolts to the spec-
ified two steps.
NOTE:
Do
not rotate the conrad with the plastigauge in place.
Conrod bolt:
st step
2nd step
N·m (0.35 kg-m, 2.5
7
N·m (0.7 kg-m, 5.0
5. Remove the conrod and the conrod cap from the crank
6. the scale on the plastigauge envelop, measure the
with the widest
Conrod big end clearance:
0.15- 0.035 mm
-0.0014
0.080 mm
the measurement exceeds the service limit replace the conrad
and/or crankshaft.
end inside diameter:
1 5-19.025 mm
-0.7490
run out
Measure the crankshaft runout as shown in the figure.
09900-20602: Dial
run out:
Service
limit: 0.05 mm
the measurement exceeds the service
shaft.
replace the crank-