6·34
POWER
CONROD
CAP
1.
Apply engine oil to the crank pin, the connecting
rod
and the
connecting
rod
cap
2. Install the conrad cap
in
the direction as shown
in
the
3. Apply engine oil
to the conrad bolts.
4. the two conrad bolts to the specified
in
two
steps.
bolt:
1st
step
3.5 N·m (0.35
2nd
step
7 N·m kg-m, 5.0
1.
Apply engine oil to the shaft
2.
Install the shaft to the cylinder block.
3.
oil to the cam faces, the cam
and the
4.
While aligning each mark on the camshaft gear and the
crankshaft
install the camshaft
(2).
To Next Page
Loading...
