88
7. Inject approximately 10 grams of grease at
initial 20 hours.
Inject approximately 5 grams of grease at
every 100 hours (12 months).
NOTE:
If grease will not inject into the fitting, consult
your Authorized Suzuki Marine Dealer.
NOTICE
Using a hydraulic or air powered grease gun
to service the grease nipple
A
on the mount
oil seal cover may cause damage to the oil
seal.
Do not use powered grease guns when servic-
ing grease nipple
A
on the mount oil seal
cover.
ANODES AND BONDING WIRES
Anodes
The motor is protected from exterior corrosion
by anodes. These pieces of anodes control
electrolysis and prevent corrosion. The anodes
will corrode in place of the parts they are pro-
tecting. You should periodically inspect each of
the anodes and replace them when 2/3 of the
metal has corroded away.
Transom “XX” only
To Next Page
Loading...
