Suzuki DR600S - Page 53

3-19
SERVICING
ENGINE
e
Remove
the
crankshaft
from
the
crankcase
by
using
a
crankshaft
remover.
0
Crankshaft
remover
eae
tale
(Crankcase
separating
tool)
ENGINE
COMPONENTS
INSPECTION
AND
SERVICING
CYLINDER HEAD SERVICING
CAUTION:
Be sure to identify each removed part as to
its location, and lay the parts out in groups
designated as ‘Exhaust’, ‘Inlet’, so that each
will be restored to the original location during
assembly
e@ Pull out the manual and automatic de-compres-
sion shafts. ® @)
@® Automatic de-compresshin shaft
@ Manual de-compression shaft |
e@ Remove the de-compression cable bracket @) by
removing the bolt, then remove the intake
rocker arm shaft set bolt @.
@ Remove the exhaust rocker arm shaft set bolt
©.