Suzuki DR600S - Page 80

CRANKSHAFT
SERVICING ENGINE 3-46
(@ Primary drive gear
@ Cam drive sprocket
@) Right crankshaft
@ Conrod
©®) Crank pin
© Left crankshaft
@) Balancer drive sprocket
@ Decide the width between the webs referring to
the figure below when rebuilding the crankshaft.
STD width 71.0 + 0.1 mm
between webs (2.79 + 0.004 in)
e@ When mounting the crankshaft in the crankcase,
it is necessary to pull its right end into the
crankcase.
09910-32812
| Crankshaft installer
09910-32830 | Attachment _
09910-32820 | Spacer
| CAUTION: a _ cay
Never fit the crankshaft into the crankcase
by striking it with a plastic hammer.
Always
use
the
special
tool,
otherwise
crank-
shaft
alignment
accuracy
will
be
affected.
a eee
71.0+0.1 mm
(2.79 + 0.004 in)