Suzuki DR600S - Page 82

e After installing the countershaft assembly and
driveshaft assembly into the right crankcase,
fit the gearshift forks (),@)and @)into the
gearshift fork grooves.
(@ For Top driven gear (No. 1)
(2) For 4th driven gear (No. 2)
@) For 3rd drive gear (No. 3)
NOTE:
Three kinds of gearshift forks, (1), @)and @)
are used. They resemble each other very
closely in external appearance and configura-
tion.
Carefully examine the illustration for correct
installing positions and directions.
© Position the gearshift cam as shown in Fig. so
that the gearshift fork shafts can be installed
easily.
When replacing the gearshift cam stopper bolt
@® , apply a small quantity of THREAD
LOCK “1342” to the threaded part of the
bolt.
e After installing the gearshift fork shafts, hook
the gearshift cam stopper spring.
NOTE:
After installing the gearshift cam stopper
spring, install the neutral switch. (See page
3-18)
SERVICING ENGINE 3-48