Suzuki DR600S - Page 88

OIL PUMP
e Before mounting the oil pump, apply engine oil
to the sliding surfaces of the case, outer rotor,
inner rotor and shaft.
e Apply a small quantity of THREAD LOCK
“1342” to the oil pump mounting screws.
99000-32050 Thread lock ‘'1342”
@ Tighten the oil pump mounting screws.
09900-09003 Impact driver set
NOTE:
After installing the oil pump driven gear,
rotate the pump gear by hand to see if it turns
smoothly.
CAM DRIVE SPORCKET
e@ Install the cam drive sprocket onto the crank-
shaft, then fit the key ( in the key slot on the
crankshaft.
@ Engage the cam drive chain onto the cam drive
sprocket.
Cin. ebheva» OREO 29 466
PRIMARY DRIVE GEAR
e Fit the key (@ in the key slot on the crankshaft,
then install the primary drive gear, washer and
nut.
e
Tighten
the
primary
drive
gear
nut
to
the
specified
torque
by
using
the
special
tool
and
torque
wrench.
| 09910-20116 | Conrod holder P|
SERVICING
ENGINE
3-54