Suzuki GW250 User Manual

5-22 FUEL SYSTEM AND THROTTLE BODY
TP RESET
When replacing the throttle body assembly or TP sensor with a
new one or reinstalling the TP sensor, reset the TP fully closed
learned value in the following procedures:
1) Set up the SDS tool. (4-24)
2) Turn the ignition switch ON.
3) Click “Active control”.
4) Click “TP fully closed learned value reset” 1.
5) Click “Reset” button 2 to clear the TP fully closed learned
value.
NOTE:
The learned value of the TP sensor is set at RESET position.
6) Close the SDS tool.
7) Turn the ignition switch OFF position.
NOTE:
The TP sensor opening initialization is automatically started
after the ignition switch is turned OFF.

Suzuki GW250 Specifications

General

Engine Type	4-stroke, 2-cylinder, liquid-cooled, SOHC
Displacement	248 cc
Bore x Stroke	53.5 mm x 55.2 mm
Compression Ratio	11.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (Transistorized)
Starter	Electric
Transmission	6-speed constant mesh
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Swingarm type, coil spring, oil damped
Front Tire	110/80-17M/C 57H, tubeless
Rear Tire	140/70-17M/C 66H, tubeless
Curb Mass	183 kg (403 lbs)
Front Brakes	Single disc
Rear Brakes	Single disc
Fuel Tank Capacity	13.3 liters
Overall Width	760 mm
Overall Height	1, 075 mm
Wheelbase	1, 430 mm
Ground Clearance	165 mm (6.5 in)
Seat Height	780 mm (30.7 in)
Overall Length	2, 145mm (84.4 inches)