5-14
6. Wipe off the mounting surface
5 on the engine where the
new filter will be seated with a
clean rag.
7. Smear a little engine oil
around the rubber gasket 6 of
the new oil filter.
8. Screw the new filter by hand
until the filter gasket contacts
the mounting surface (a small
resistance will be felt).
NOTE: To tighten the oil filter
properly, it is important to accu-
rately identify the position at
which the filter gasket first con-
tacts the mounting surface.
CAUTION
Failure to use the correct oil fil-
ter can damage your ATV.
Engine damage may occur if
you use oil filter with the wrong
design or thread specifica-
tions.
Be sure to use a genuine
SUZUKI oil filter or an equiva-
lent filter designed for your
ATV.
To Next Page
Loading...
