5-20
GEAR OIL CHANGE
Inspect and change the gear oil
according to the MAINTENANCE
SCHEDULE. When changing the
gear oil, use SAE90 hypoid gear
oil which is rated GL-5 under the
API classification system. If you
operate the LT-F400F where the
ambient temperature is normally
below 0°C (32°F), use SAE 80
hypoid gear oil. The procedure for
changing the front and rear gear
oil is as follows:
Front differential gear oil (LT-F400F)
Final gear oil
1. Park the vehicle on level
ground.
2. Remove the cover under the
gear case.
3. Remove the oil filler cap 1 for
the front differential gear or the
filler cap 3 for the final gear.
Front differential gear oil (LT-F400F)
Final gear oil
4. Remove the drain plug 4 or 5
from the bottom of the gear
case and drain the oil into a
drain pan.
5. Reinstall the drain plug and
tighten it securely after all the
oil has been drained out.
Remove the bolt 2 or 6. Pour
fresh oil through the filler hole
until the oil flows out from the
oil level hole 2 or 6.
6. Tighten oil filler caps securely.
Front differential gear oil:
300 ml (10.1 US oz)
Final gear oil:
350 ml (11.8 US oz)
To Next Page
Loading...
