3-7
THROTTLE LIMITER
Use the throttle limiter to restrict max-
imum engine power by limiting throttle
lever travel. Adjust this limiter accord-
ing to the rider’s skill and experience.
NOTE: The throttle limiter position A
is preset at 9.7 mm (0.382 in) from
the factory.
To adjust the throttle limiter:
1. Loosen the lock nut 1.
2. Turn the throttle limiter screw 2
clockwise or counterclockwise to
adjust maximum engine power.
Turning the screw clockwise will
restrict maximum engine power.
3. Tighten the lock nut 1.
This ATV comes from the factory with
a maximum speed reduction spacer
installed in the drive train system and
the throttle limiter set for a maximum
speed of approximately 13 km/h (8.5
mph). You can decrease the maxi-
mum vehicle speed further by adjust-
ing the throttle limiter according to the
previous procedure. When the rider
has developed sufficient skill and
experience to operate the ATV safely
at higher speeds, you can increase
the maximum speed capability of the
ATV by removing the maximum speed
reduction spacer from the drive train
system.
NOTE: Removing the maximum
speed reduction spacer requires spe-
cial tool for loosing and tightening the
nut. Ask your Suzuki dealer to remove
the spacer.
WARNING
Removing the maximum speed
reduction spacer before the rider
has developed sufficient skills to
operate the ATV safely is hazard-
ous.
Riding at excessive speeds
increases chances of losing con-
trol of the ATV, which can result in
an accident.
Do not remove the maximum
speed reduction spacer until the
rider develops sufficient skills to
operate LT-Z50 safely at the maxi-
mum speed with the maximum
speed reduction spacer in place.
To Next Page
Loading...
