ENGINE MECHANICAL (K9K ENGINE) 6A2-33
Installation
Reverse removal procedure for installation noting the following.
• Tighten engine mounting nuts (1) to specified torque.
Tightening torque
Engine mounting nut (a):
55 N·m (5.5 kg-m, 40.0 lb-ft)
• Install transmission assembly referring to “Transmission Dis-
mounting and Remounting” in Section 7A2.
• Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
• Refill engine oil referring to “Engine Oil and Filter” in Section
0B.
• Refill cooling system referring to “Coolant Replacement” in
Section 6B2.
• After connecting discharge hose pipe to A/C compressor,
charge A/C system referring to “Charging Procedure” in Sec-
tion 1B.
• Check to make sure that there is no fuel leakage, oil leakage,
coolant leakage, refrigerant and exhaust gas leakage at
each connection.
CAUTION:
Before installing intake air pressure sensor hose,
degrease connect part of hose and intercooler outlet
hose. Otherwise hose may become detached and cause
turbo system failure.
1, (a)
1, (a)
To Next Page
Loading...
