ENGINE MECHANICAL (K9K ENGINE) 6A2-45
3) Remove oil pump (1) from cylinder block.
4) Remove timing belt referring to “Timing Belt and Belt Ten-
sioner Removal and Installation” in this section.
5) Remove gasket holder plate (1).
6) Remove gasket holder plate oil seal (2).
7) Remove oil pump chain (1) and oil pump drive sprocket (2).
Installation
1) Install oil pump (1), oil pump chain (2) and oil pump drive
sprocket all together.
Tighten oil pump bolts to specified torque.
Tightening torque
Oil pump bolt (a): 25 N·m (2.5 kg-m, 18.0 lb-ft)
To Next Page
Loading...
