10
RIGHT
CLAMP
Clamp the right switch wiring harness and front brake
hose union with strap.
A: Strap L:140 mm
B: Front brake hose union
C: Right switch wiring harness
LEFT
Clamp the left switch wiring harness and clutch cable
with strap.
A: Strap L:140 mm
B: Clutch cable
C: Left switch wiring harness
HANDLEBAR BALANCER
Assemble the handlebar balancer parts as shown.
A: 6 × 65 mm screw
B: Balancer weight
C: Rubber cushion L:15.0 mm
D: Spacer L:15.0 mm
E: Rubber cushion L:15.0 mm
F: 6 mm spacer nut
With the screw not tightened, insert the balancer sub-
assembly into the handlebar end all the way, then
tighten the screw securely.
A: Balancer assembly
NOTE:
Cut off the excess strap as shown in the photo-
graph.
OUTSIDE
NOTE:
Cut off the excess strap as shown in the photo-
graph.
OUTSIDE
Check to ensure that the throttle operates freely
and closes automatically.
To Next Page
Loading...
