8
A: Bolt
B: Holder
C: Front brake master cylinder
D: Handlebars
Connect the lead wires coupler to the front brake light
switch.
A: Front brake light switch
B: Lead wire coupler
LEFT SWITCH
Insert the boss of left switch housing into the hole on
the handlebars.
Install the left switch assembly with two screws.
A: Boss
B: Hole
C: Holder
D: 5 × 45 mm screw
E: 5 × 25 mm screw
NOTE:
Install the holder in position according to the
mark “UP”.
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
Check to ensure that the holder is set the cor-
rect position.
Be careful not to pinch the wiring harness.
To Next Page
Loading...
