2-108
BEFORE DRIVING
80SS5-01E
Information shown after driving
When you turn the ignition switch to “LOCK”
position or press the engine switch to
change the ignition mode to LOCK (OFF),
the following information appears for sev-
eral seconds on the information display.
52RM21140
Selector position (for automatic
transmission or CVT vehicles) /
Gear position (for automatic trans-
mission vehicles) / Gearshift indica-
tor (if equipped)
The display (D) shows some of the follow-
ing indications.
80SM105
(18) Selector position
(19) Gear position
(20) Manual mode indicator
Selector position (for automatic trans-
mission or CVT vehicles) / Gear posi-
tion (for automatic transmission
vehicles)
The display shows the transmission selec-
tor position (16) or the gear position (17).
• When the manual mode is not in use, the
display shows the selector position.
• When using the manual mode, the dis-
play shows the current gear position.
Manual mode indicator (for automatic
transmission vehicles)
When you are using the manual mode, the
display shows the manual mode indicator
(18).
Gearshift indicator (if equipped)
Refer to “Gearshift indicator” in “OPERAT-
ING YOUR VEHICLE” section.
Trip meter
The display (E) shows the trip meter.
The trip meter can be used to measure the
distance traveled on short trips or between
fuel stops.
You can use trip meter A or trip meter B
independently.
To reset the trip meter, push and hold the
trip meter selector knob (2) for about 2
seconds when the display shows the trip
meter.
Odometer
The display (F) shows the odometer.
The odometer records the total distance
the vehicle has been driven.