2-111
BEFORE DRIVING
80SS5-01E
IS A/C
(ENG A-STOP system setting)
• When using the automatic heating and
air conditioning system (if equipped),
you can select one of the following
engine auto stop settings.
– Standard
– Economy
–Comfort
• When “Economy” is selected, engine
auto stop condition is eased, compared
with “Standard”. As engine auto stop
condition will occur more frequently, the
stop time will be longer, leading to reduc-
tion of fuel consumption.
• When “Comfort” is selected, engine auto
stop condition becomes severe, com-
pared with “Standard”. As engine auto
stop condition will occur less frequently,
the stop time will be shorter, leading to
more comfortable cabin condition by air
conditioner.
TPMS
(Tyre pressure monitoring system set-
ting) (if equipped)
• You can check the current tyre pressure
on the information display.
• You can set one of the initial values of
tyre pressure below that are indicated on
the tyre information label.
– Comfort Mode
– Load Mode
Refer to “Tyre pressure monitoring system
(TPMS) (if equipped)” in “OPERATING
YOUR VEHICLE” section for details.
BSM setting (if equipped)
If you select “ON” the Blind Spot Monitor
(BSM) or Rear Cross Traffic Alert (RCTA)
can be activated. Refer to “Blind Spot Mon-
itor (BSM)” or “Rear Cross Traffic Alert
(RCTA)” in the “OPERATING YOUR VEHI-
CLE” section for details.
Display item
(“Calendar dis” setting)
You can select whether you show the cal-
ender on the information display or not.
(“Calendar form” setting)
You can change the calendar form of the
information display.
To change the calendar form, select “Cal-
endar form” in “Display item”. Then, select
the display order of date, month and year.
(“Fuel eco hist” setting)
Transitional indication of average fuel con-
sumption can be switched to time indica-
tion and driving cycle indication.
(“Motion hist” setting)
Indication of G position history graph at the
vehicle stopped can be selected to enable
or disable.
(“Idling disp” setting) (if equipped)
Display of ENG A-STOP operation with
ignition mode LOCK (OFF) is selectable to
indicate or not to indicate.
(“Idling warn” setting) (if equipped)
You can switch whether the information
display shows the warning and indicator
messages related on the ENG A-STOP
system.
(“Pedal op dsp” setting)
Display of “Accelerator and brake” is
selectable to indicate or not to indicate.
(“Regen disp” setting) (if equipped)
You can choose that the deceleration
energy regenerating indicator light comes
on or does not come on.
Default
(Initialization setting)
If you select “YES” and push the indicator
selector knob (3), all settings will be reini-
tialized.
To Next Page
Loading...
Need help?
General
