8-5
EMERGENCY SERVICE
80SS5-01E
NOTE:
For more details, contact an authorized
SUZUKI dealer.
Changing wheels
To change a wheel, use the following pro-
cedure:
1) Prepare the jack (if equipped), tools
and spare tyre (if equipped).
2) Loosen, but do not remove the wheel
nuts.
3) Jack up the vehicle (follow the jacking
instructions in this section).
4) Remove the wheel nuts and wheel.
65J4033
5) Clean any mud or dirt off from the sur-
face of the wheel (1), hub (2), thread
part (3) and surface of the wheel nuts
(4) with a clean cloth.
Clean the hub carefully; it may be hot
from driving.
NOTICE
Never apply a garage jack to the
exhaust pipe, side under spoiler (if
equipped), engine undercover or rear
torsion beam.
WARNING
• Shift into “P” (Park) for an automatic
transmission or CVT, or into “R”
(Reverse) for a manual transmission
vehicle when you jack up the vehicle.
• Never jack up the vehicle with the
transmission in “N” (Neutral). Oth-
erwise, unstable jack may cause an
accident.
CAUTION
Immediately after the vehicle has
been driven, the wheels, the wheel
nuts and the area around the brakes
might be extremely hot.
Touching these areas may cause
burn injury. Do not touch these areas,
immediately after the vehicle has
been driven.
(2)
4
(1)
(3)
To Next Page
Loading...
