8-6
EMERGENCY SERVICE
80SS5-01E
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
Except for sport model
52RM80070
Sport model
81A057
Tightening torque for wheel nut
100 Nm (10.2 kg-m, 74.0 lb-ft)
7) Lower the jack and fully tighten the nuts
with a wheel wrench in numerical order
as shown in the illustration.
52RM603
Return the spare tyre back into the lug-
gage compartment in the reverse order of
removal and tighten its bolt (5) clockwise
as shown in the above illustration.
WARNING
Use genuine wheel nuts and tighten
them to the specified torque as soon
as possible after changing wheels.
Incorrect wheel nuts or improperly
tightened wheel nuts may come
loose or fall off, which can result in
an accident. If you do not have a
torque wrench, have the wheel nut
torque checked by an authorized
SUZUKI dealer.
NOTICE
Make sure that the spare tyre is fixed
securely on the floor. Loosely fixed
tyre may cause noise during driving
and damage paint on vehicle body.
(5)
To Next Page
Loading...
Need help?
General
