3-29
BEFORE DRIVING
69TB-01E
Wiper and washer operation
When the ignition mode is ON, you can
use the wiper/washer lever.
When the wipers are under heavy load
such as covered by snow, the breaker will
be activated and the wipers will stop oper-
ating to protect the wiper motor from over-
heating.
If the wiper stops during operation, do the
following methods.
1) Stop the vehicle in a safe place, and
turn the engine off.
2) Move the wiper lever and switch to
“OFF” position.
3) Remove obstacles such as snow on the
wipers.
4) After a while, when the temperature of
the wiper motor becomes low enough,
the breaker will be reset automatically
and the wipers will be able to use.
If you cannot use the wipers after a while,
there may be another problem. Ask an
authorized SUZUKI dealer or a qualified
workshop to have the wipers inspected.
Windshield wipers
68PM00237
You can operate the windshield wipers by
moving the lever upward or downward.
68PM00238
The lever is equipped with the “INT TIME”
control. Turn the control forward or rear-
ward to adjust the intermittent wiper opera-
tion to the desired interval.
MIST
Temporary operation only
while the lever is up
OFF Off
INT Intermittent operation
LO Low speed operation
HI High speed operation
To Next Page
Loading...
Need help?
General
