4-55
INSTRUMENT CLUSTER
69TB-01E
Driver Monitoring System OFF indi-
cator light
69TJ010170
When the engine switch is pressed to
change the ignition mode to ON, this light
comes on briefly so you can check that the
light is working.
When the driver monitoring system is
turned off by changing the setting mode of
information display, this indicator light
comes on.
When the driver monitoring system is tem-
porarily stopped, this light comes on.
When the driver monitoring system is mal-
function, this light blinks. Bring the vehicle
to an authorized SUZUKI dealer or a quali-
fied workshop to have the problem cor-
rected.
Oil change request light
(if equipped)
79JM007
Your vehicle has the oil life monitoring sys-
tem and related oil change request light
that alerts you to change the engine oil and
oil filter.
When this light comes on, change engine
oil and oil filter immediately.
For details on how to change the engine oil
and oil filter, refer to “Changing engine oil
and filter” (P.9-24).
This light comes on for several seconds
when the engine switch is pressed to
change the ignition mode to ON so you
can check that light is working.
If either of odometer reading or time is
reached to the value which is set by the
system, this light comes on when the
engine switch is in “ON” position. In addi-
tion, the message is shown on the informa-
tion display to tell you it is necessary to
change the engine oil and oil filter. When
the engine oil and oil filter are changed and
the oil life monitoring system is reset, this
light will go out. For details of the mainte-
nance schedule, refer to “Periodic mainte-
nance schedule” (P.9-3).
Whenever the engine oil and oil filter are
changed, the light must be reset to monitor
the next oil change timing properly. The
light will go out after the reset. For the
resetting procedure, refer to
“Setting mode
of information display” (P.12-8)
.
NOTE:
• This light is used to facilitate the oil and
oil filter change according to the mainte-
nance schedule.
• Even though the oil is replaced before
this light comes on, reset of the oil life
monitoring system is necessary. Consult
an authorized SUZUKI dealer or a quali-
fied workshop about the reset method. If
you reset it by yourself, refer to
“Setting
mode of information display” (P.12-8)
.
• Consult an authorized SUZUKI dealer or
a qualified workshop for changing the
setting of oil life monitoring system in
one of the following cases;
– For European countries and Israel, if
you replace ACEA Standards or
SUZUKI genuine engine oil by the
NOTICE
Severe engine damage will result, if
you keep operating the engine after
this light comes on.
Change the engine oil and oil filter
immediately when the light blinks.
To Next Page
Loading...
Need help?
General
