5-64
OPERATING YOUR VEHICLE
69TB-01E
NOTE:
Situations in which the front camera
(DSBS II) and front radar (DSBS II)
may not operate properly
• When the height or inclination of the
vehicle has been changed due to modifi-
cations
• When the windshield is dirty, fogged up,
cracked or damaged
• When a sensor is extremely hot or cold
• When mud, water, snow, dead insects,
foreign matter, etc., is attached to the
front of the sensor
• When in inclement weather such as
heavy rain, fog, snow, or a sandstorm
• When water, snow, dust, etc. is thrown
up in front of the vehicle, or when driving
through mist or smoke
• When the headlights are not illuminated
while driving in the dark, such as at night
or when in a tunnel
• When the lens of a headlight is dirty and
illumination is weak
• When the headlights are misaligned
• When a headlight is malfunctioning
• When the headlights of another vehicle,
sunlight, or reflected light shines directly
into the front camera (DSBS II)
• When the brightness of the surrounding
area changes suddenly
• When driving near a TV tower, broad-
casting station, electric power plant,
radar equipped vehicle, etc., or other
location where strong radio waves or
electrical noise may be present
WARNING
(Continued)
When installing the license plate
on the front bumper
69T050600
(1) Front radar (DSBS II)
(2) Base plate
(3) License plate and license plate
frame (sizes vary depending on the
country and region)
• The license plate and license plate
frame (3) must be installed on the
base plate (2).
• The front radar (DSBS II) (1) is posi-
tioned as shown in the illustration.
If you do not install the license
plate directly on the base plate (2),
or install the license plate by pro-
truding upwards from the base
plate (2), emission/reception of the
front radar (DSBS II) can be inter-
rupted and the system may mal-
function.
(Continued)
(1)
(3)
(2)
(Continued)
69T050600
• Do not install the license plate and
license plate frame (3) so that the
warning label (4) is visible. Install
them so that the warning label (4) is
hidden. The license plate and
license plate frame (3) must be
installed securely on the base plate
(2) by using self-tapping screws.
• We recommend you to ask your
authorized SUZUKI dealer to install
the license plate.
WARNING
(4)