5-108
OPERATING YOUR VEHICLE
69TB-01E
Adaptive cruise control with traffic
sign recognition (if equipped)
When traffic sign recognition function is
enabled and the adaptive cruise control is
operating, if a speed limit sign is detected,
the detected speed limit will be displayed
with an up/down arrow. The set speed can
be increased/reduced to the detected
speed limit by pressing and holding the
“RES +” switch or “–” switch.
• When the set speed is lower than the
detected speed limit
69T050450
Press and hold the “RES +” switch when
the UP arrow is indicated in the information
display.
• When the set speed is higher than the
detected speed limit
69T050460
Press and hold the “–” switch when the
DOWN arrow is indicated in the informa-
tion display.
• Enabling/disabling the adaptive cruise
control with traffic sign recognition
The adaptive cruise control with traffic sign
recognition can be enabled/disabled
through a customize setting. Refer to “Set-
ting mode of information display” (P.12-8).
NOTE:
The adaptive cruise control with traffic
sign recognition may not operate prop-
erly when
As the adaptive cruise control with traffic
sign recognition may not operate properly
in situations where the traffic sign recogni-
tion may not operate or cannot detect
signs correctly, when using this function,
make sure to confirm the actual speed
limit.
In the following situations, the set speed
may not change to the detected speed limit
by pressing and holding the “RES +”
switch or “–” switch:
• When speed limit information is not
available
• When the detected speed limit is the
same as the set speed
• When the detected speed limit is outside
of the speed range which the adaptive
cruise control can operate
Changing Adaptive cruise control
settings
The settings of the adaptive cruise control
can be changed through customize set-
tings. Refer to “Setting mode of information
display” (P.12-8).
To Next Page
Loading...
Need help?
General
