5-119
OPERATING YOUR VEHICLE
69TB-01E
Changing the settings of the curve
speed reduction function
Various settings of the curve speed reduc-
tion function can be changed through cus-
tomize settings. Refer to “Setting mode of
information display” (P.12-8).
Overtaking prevention function
(if equipped)
If a detected vehicle in the passing lane is
traveling slower than your vehicle, overtak-
ing will be suppressed.
The overtaking prevention function will not
operate if the passing lane is congested or
vehicles are traveling at low speeds.
Support for lane change
If your vehicle is being driven at approxi-
mately 80 km/h (50 mph) or more and a
lane change to the passing lane is per-
formed, when the turn signal control lever
is operated for lane changing, the vehicle
will accelerate up to the set speed to assist
in overtaking.
If your vehicle is being driven at approxi-
mately 80 km/h (50 mph) or more and the
lane is changed to that with a vehicle trav-
eling slower than your vehicle, when the
turn signal control lever is operated the
vehicle will gradually decelerate to assist in
changing lanes.
Adaptive cruise control with traffic
sign recognition (if equipped)
When traffic sign recognition function is
enabled and the adaptive cruise control is
operating, if a speed limit sign is detected,
the detected speed limit will be displayed
with an up/down arrow. The set speed can
be increased/reduced to the detected
speed limit by pressing and holding the
“RES +” switch or “–” switch.
• When the set speed is lower than the
detected speed limit
69T050450
Press and hold the “RES +” switch when
the UP arrow is indicated in the information
display.
• When the set speed is higher than the
detected speed limit
69T050460
Press and hold the “–” switch when the
DOWN arrow is indicated in the informa-
tion display.
• Enabling/disabling the adaptive cruise
control with traffic sign recognition
The adaptive cruise control with traffic sign
recognition can be enabled/disabled
through customize settings. Refer to “Set-
ting mode of information display” (P.12-8).
NOTE:
The adaptive cruise control with traffic
sign recognition may not operate prop-
erly when
As the adaptive cruise control with traffic
sign recognition may not operate properly
in situations where the traffic sign recogni-
tion may not operate or cannot detect
signs correctly, when using this function,
To Next Page
Loading...
Need help?
General
