5-146
OPERATING YOUR VEHICLE
69TB-01E
NOTE:
If body wax gets on the camera lens, wipe
off the wax with a clean cloth dampened
with mild detergent diluted with water, and
then wipe the lens with a dry cloth.
How to use rearview camera
1) Press the engine switch to change the
ignition mode to ON.
2) Shift the gearshift lever in “R” position.
• The display automatically shows the
view behind the vehicle.
• When the gearshift lever is shifted
from “R” to another gearshift lever
position, the display returns to the
previous display.
NOTE:
The rearview camera display has first pri-
ority in any display mode. However, the
rearview camera display does not show
the rear view while the system is initializ-
ing.
Display range of rearview camera
The rearview camera display shows the
area behind the rear end of the bumper.
The display cannot show objects which are
close to the bumper or under the bumper.
The rearview camera display cannot show
obstacles which are higher than the cam-
era. Upper parts of tall objects such as
road signs cannot be viewed on the dis-
play.
Display range of rearview camera
69T050350
69T050360
(a) Display range
(Continued)
• If water enters the rearview camera,
it may cause a malfunction or catch
fire.
Do not use high pressure water
around the camera.
• This lens is hard coated to prevent
damage or discoloration. Damage
or discoloration of lens may
obscure the image.
– Do not use a brush to clean lens.
– Do not use alcohol, benzene or
thinner to clean the lens.
– Do not use wax on the camera
lens.
NOTICE
(a)
(a)
To Next Page
Loading...
Need help?
General
