5-162
OPERATING YOUR VEHICLE
69TB-01E
NOTE:
For a certain type of instrument cluster
only, the information display shows the
above warning and indicator message
when this light comes on.
TPMS limitations
The tyre pressure monitoring system may
not function properly under certain circum-
stances. In the following situations, the low
tyre pressure warning light may come on
and remain on or may blink.
• When you replace a flat tyre with the
spare tyre.
• When you include a spare tyre during a
tyre rotation.
• When the TPMS sensor is damaged
during a tyre replacement or liquid seal-
ants are used to repair a flat tyre.
• When the electronic signal of TPMS sen-
sor is disturbed in one of the following
ways:
– Electric devices or facilities using simi-
lar radio wave frequencies are nearby.
– A metallic film that may cause radio
wave interference is attached on the
window.
– A lot of snow or ice covers the vehicle,
in particular, around the wheels or
wheel housings.
– Snow tyres that are not installed with
genuine TPMS sensors or tyre chains
are used.
• When you use non-genuine SUZUKI
wheels or tyres.
• When the pressure of any tyre is too
high.
• When there is a problem with the
receiver of the TPMS controller.
TPMS setting
• You can check the current tyre inflation
pressure on the information display.
• You can set one of the initial value of tyre
pressure below that is indicated on the
tyre information label.
– Comfort mode
– Load mode
69T051060
“SERVICE
TPMS”
WARNING
If the loading weight has changed,
adjust the tyre pressure according to
the tyre information label and set the
initial value via the information dis-
play. If the loading weight, tyre pres-
sure and initial value do not match,
the tyre pressure monitoring system
will not function properly.
To Next Page
Loading...
Need help?
General
