5-164
OPERATING YOUR VEHICLE
69TB-01E
69T051090
(3) Tyre pressure
4) The display shows current tyre inflation
pressure.
NOTE:
• If the low tyre pressure warning light
comes on, the information display will be
switched to “Tyre Pressure” display and
the corresponding tyre pressure indica-
tion blinks to alert you which tyre(s) is
(are) low pressure.
• The display may not show the tyre infla-
tion pressure for about 10 minutes after
the vehicle begins to move. This is
because the TPMS system learns the
tyre inflation pressure within this 10 min-
utes. The display will show the tyre infla-
tion pressure after 10 minutes pass.
• If you stop the vehicle and change the
ignition mode to LOCK (OFF), and leave
it for 20 minutes or more, tyre pressure
will be reset and will be indicated as 0
kPa when the engine is restarted. In this
case, the current tyre pressure indication
will recover after driving for a while.
However, if any of tyre pressures has
been detected as low pressure before
stopping the engine, the tyre pressure
indication may not recover and may be
indicated as “---”.
To set the initial value of tyre pressure
69T051510
1) When the ignition mode is ON and the
vehicle is stationary, push and hold the
indicator selector knob (1) on the instru-
ment cluster for more than 3 seconds to
change the information display to the
setting mode.
(1)
To Next Page
Loading...
Need help?
General
