7-23
OTHER CONTROLS AND EQUIPMENT
69TB-01E
System operating instructions
To set the air conditioning system, follow
the procedure below.
1) Start the engine.
2) Set the desired blower speed by push-
ing upper part or lower part of the
blower speed selector (2).
3) Set the desired temperature by pushing
upper part or lower part of the tempera-
ture selector (1).
You can use the air conditioning switch (6)
to manually turn the air conditioner on or
off according to your preference. When
you turn the air conditioning switch off, the
air conditioning system cannot lower the
inside temperature below the outside tem-
perature.
To turn the air conditioning system off,
push the “OFF” switch (7).
Normal cooling
Set the air flow selector (4) to VENTILA-
TION (c), the temperature selector (1) to
the desired temperature position and the
blower speed selector (2) to the desired
blower speed position. Setting the blower
speed selector (2) to a higher blower
speed position increases cooling effi-
ciency.
You can switch the air intake selector (3) to
either FRESH AIR (b) or RECIRCULATED
AIR (a) as you desire. Choosing RECIR-
CULATED AIR (a) increases cooling effi-
ciency.
Quick cooling (using recirculated air)
The base settings are the same as for nor-
mal cooling except you select RECIRCU-
LATED AIR (a) and the highest blower
speed.
To cool down the interior at peak efficiency,
push the maximum cooling switch (8).
NOTE:
• If you select RECIRCULATED AIR (a)
for an extended period of time, the air in
the vehicle can become contaminated
and the windows tend to get misted.
Therefore, you should select FRESH
AIR (b) whenever possible.
• If your vehicle has been left in the sun
with the windows closed, it will cool
faster if you open the windows briefly
while you operate the air conditioner with
the air intake selector at FRESH AIR (b)
and the blower at high speed.
Dehumidifying
Set the air flow selector (4) to the desired
air flow selector position, the temperature
selector (1) to the desired temperature
position and the blower speed selector (2)
to the desired blower speed position. Also
select FRESH AIR (b).
NOTE:
• Because the air conditioner dehumidifies
the air, turning it on will help keep the
windows clear.
• If the heating performance can no longer
perform at a sufficient level due to auto-
matically stopping the engine, press the
ENG A-STOP OFF switch to deactivate
the ENG A-STOP system. (The engine
will automatically restart and the air con-
ditioning performance will be restored.)
• If the windshield and/or the driver’s side/
passenger side door windows are
fogged during automatically stopping the
engine, stop the ENG A-STOP system
and restart the engine. Then, push the
air flow selector (4) to change the air
flow to the HEAT & DEFROST or
DEFROST position to defog the win-
dows.
To Next Page
Loading...
Need help?
General
