10-4
EMERGENCY SERVICE
69TB-01E
69T100010
1) Remove the cover (1) by using a jack
handle (3) (if equipped) or flat-bladed
screwdriver, etc. covered with a soft
cloth (2) as shown in the illustration.
NOTE:
We recommend that you fasten the cover
with tape to prevent damage during tow-
ing.
69T100020
2) Install the towing eye (4) by hand.
69T100030
3) To tighten the towing eye (4), turn it
clockwise by using a wheel wrench (5)
(if equipped) or hard metal bar until the
towing eye (4) is securely installed.
NOTICE
Do not apply excessive force as it
may damage the cover strap.
(4)
(4)
(5)
NOTICE
• Observe the following instructions
when using the towing eye (4). Oth-
erwise, the towing eye or the vehicle
body may break and cause serious
injury or damage:
– Avoid pulling the vehicle to get out
of severe snowy, muddy or sandy
conditions.
– Avoid sudden starts or erratic
driver performance which could
cause excessive stress on the
towing eye.
In such cases, we recommend that
you contact a professional service.
• Do not use the
towing eye
(4) for
towing another vehicle or trans-
porting your vehicle by a car carrier
trailer, etc.
To Next Page
Loading...
