10-8
EMERGENCY SERVICE
69TB-01E
How to use eCall
The eCall has 2 modes, automatic opera-
tion mode and manual operation mode.
Left hand drive vehicle
69T100100
Right hand drive vehicle
69T100110
(1) “SOS” button
(2) eCall microphone
(3) Green indicator
(4) Red indicator
(5) Cover
Automatic operation mode
The eCall system is operated when the
engine switch is pressed to change the
ignition mode to ON. In the event of an
accident that an airbag is activated, signals
about your vehicle’s various information
such as the vehicle’s position are sent
automatically to the emergency contact
center.
The green indicator (3) will change from a
blinking state to on, and you can call up an
emergency contact center operator using
the microphone (2).
Manual operation mode
Open the cover (5) for manual operation.
When the engine switch is pressed to
change the ignition mode to ON, push and
hold “SOS” button (1) for more than 1 sec-
ond and release it.
The green indicator (3) will change from a
blinking state to on, and you can call up an
emergency contact center operator using
the microphone (2).
NOTE:
(Only for manual operation mode)
Do not perform a test operation in order to
confirm the function using manual opera-
tion.
Cancel the operation if the system is acci-
dentally operated. Refer to “Cancellation of
eCall” (P.10-12) for details.
NOTE:
(For both automatic and manual operation
modes)
• A tone will sound when the cancellation
period by manual operation and the
emergency call operates for calling up.
• The vehicle information (for example,
the vehicle location, direction, VIN, acci-
dent time, etc.) is sent to the emergency
contact center when eCall operates. The
above information will not be sent except
when the emergency call is performed.
• Any conversation held during communi-
cation is not recorded by the vehicle
itself, but is recorded by the emergency
contact center.
(3) (4)
(1)
(5)
(2)
To Next Page
Loading...
Need help?
General
